How To Repair An Ethernet Port
Introduction
This guide will teach you how to access the motherboard in society to replace the Ethernet ports.
-
-
Remove the antennas by unscrewing them from the base.
-
Flip over the device and locate the iv safety anxiety on the bottom.
-
Remove the condom anxiety with tweezers
-
-
-
Remove the 0.4cm head screws from each slot with the #1 Phillips head Screwdriver.
-
-
-
Use a blue plastic opening tool to remove the elevation cover.
-
Motility the bluish plastic opening tool gently underneath the top embrace from side to side.
-
-
-
Gently lift the motherboard and remove it from the case
-
Put the motherboard over a (preferably white) surface.
-
-
-
Locate the Ethernet ports
-
Flip the motherboard and locate the 40 solder points respective to the Ethernet ports
-
Melt the 40 solder points using a soldering gun.
-
-
-
Hold the motherboard downwardly and use the spudger to remove the Ethernet Ports.
-
Almost done!
To reassemble your device, follow these instructions in opposite order.
Conclusion
To reassemble your device, follow these instructions in reverse order.
Team
One Comment
Source: https://www.ifixit.com/Guide/Ethernet+Port+Replacement/69228
Posted by: holmquistproaderescid41.blogspot.com
Tin you make a guide to supervene upon the antenna base connector, mine get cleaved at the base, I wonder if it is possible to make the cable connection directly to the antenna, does that could work?
Enrique Jendrix - Reply